Categories

Advertising

AXIS AUTHORIZED PARTNER ".....Menerima pemasangan dan Perbaikan CCTV... "

Controller for Door

FALCO IP Door Access Controller
designed in a secure technology by utilized Falco proprietary protocol

More details


Rp.0

Advanced Design

The Falco door controller uses the latest state-of-the-art flash memory technology which allows firmware upgrade. .Essential equipment settings, card database and transaction database are stored in EEPROM, so that there is no loss of data during power outage.

 

Multiple Entry Access Mode

There are 3 different entry access modes that you can set to adjust to your security requirements: Card only, PIN only and Card & PIN only. This means a door can be programmed to operate on different entry access mode at either same or different time for each day of the week, including weekends and holidays. For example, a door can be programmed to operate on 'Card only' entry mode during office hours but automatically switch to 'Card & PIN only' entry mode after office hours.

 

Use of Single Card to Perform Multiple Functions

The prowess of the Falco door controller is its ability to allow a single card to perform multiple functions through software control. The types of functions consist of normal access control, programming, Arm/DisArm, guard tour, etc.

 

Schedules Settings

Up to 50 sets of weekly timers, where each daily timer consists of 3 sets of start and stop time interval settings can be used for system behavior control. These timers are also tagged to a day-of-week selection, which are used for all timers related operations, such as locking and unlocking of doors, activating of User PIN function, etc.

 

Automatically Locking and Unlocking of Door

Quite often you may want to unlock the office main entrance door during office hours, but the door shall be locked during lunch break and after office hours. This requirement can be achieved through timer(s) controls.

 

Power Supply

Falco Controller comes with battery charging and a power regulation circuit. The input power requirement is 14VAC, and a lead-acid battery can be connected to the charger output. In addition, AC power failure, low battery cut off and battery low status sensing are built-in.

 

-          Supports firmware  upgrade via IE

-          Compatible with various reader technologies

-          Interlocking

-          Built-in web server

No customer comments for the moment.

Only registered users can post a new comment.

User Online

User Online: 1
Today Accessed: 355
Total Accessed: 67360
Your IP: 54.224.102.26

New products

No new products at this time